COMMBOX-600


Home / Outdoor Controllers

COMMBOX-600 Outdoor Snow Melting Controller


  

How long should I program my CommBox to melt snow?


It will vary depending on the depth of the cable in the material (concrete, pavers or asphalt) and the voltage input into the cable (280-240-277). Click “Read More” for details. 

Will any third party sensor work with the CommBox or ResiBox?


The CommBox and Resibox have been programmed to work with a variety of third-party sensors. Click “Read More” for details.

How many Mats or Amps can I connect to the CommBox?


The CommBox-600 is equipped with four (4) 50Amp 3-Phase relay contactors. This means that at 2-phase, you can connect up to 200 Amps worth of power, but at 3-phase, you can connect 150A per contactor. The relays are rated for 120-600 volts so the CommBox can be wired for 208, 277 and 480 using 3-Phase.

Can one AirSense be used with two CommBoxes?


Out of the box, no. Each ‘box’ will need its own sensor to trigger. Click “Read More” for more details. 

Can I use the Commbox or Resibox with single phase electric?


The BOX system can be used with single-phase electric power. Click “Read More” for details.

Do I need to provide a transformer to wire in 3-phase?


To wire in 3-phase you need 3-phase supply power. Click “Read More” for details.

Where are the DIP switches located on the COMMBOX-600?


The four DIP switches are located on the back of the thermostat unit on back of the door as shown in picture. Click “Read More” for details.

What do each of the COMMBOX DIP Switches Mean?


Click “Read More” for further information. 

What Does the HI/LO Error message mean on my COMMBOX?


The HI/LO error message means that the ambient sensor readings (on snow sensor) are out of reliable measuring range. Click “Read More” for details.

What does COMMBOX error code “SensErr 2” mean?


Error 2 “SensErr 2” will appear when the upper limit sensor is not connected or has short-circuited. Click “Read More” for details. 

What does COMMBOX error code “SensErr 1” mean?


Error 1 “SensErr 1” will appear when there is a communication error with one (or more) snow sensors. Click “Read More” for details. 

Programming your COMMBOX-600


The COMMBOX-600 is a “Plug and Play” controlled power distribution panel for frost protection, ice and snow melting projects. When receiving a signal from the sensor(s)m the contactors are activated, energizing your heating system. DIP switch settings determine how the zones activate. When programming your system, make sure DIP switch 1 is in the ON position. The program manual can be navigated by using the SELECT (+) to move forward or SELECT (-) to go back through settings.

What are the amperage capabilities of each Box at each voltage?


The amperage capacity of the Resibox is 120A and for the Commbox it is 230 Amps. The Resibox has (4) of the 30A/2-pole contactors rated 120-277V for a total of maximum 120A load capacity. Click “Read More” for details. 

Bathroom Collection
Floor Heating
Insulation
Outdoor Controllers
Outdoor Sensors
Pipe Trace
Repairs
Snow and Ice Melting
Thermostats
Scroll to Top