Quick Menu
-
Installation
- Where do I place the sensor probe when installing the DCM-PRO cables?
- How do I turn on my system?
- Master/Relay (relay reading ER1)
- Can my sensor probe be extended?
- Do you have to wire the floor sensor probe that comes with the 3iE thermostat?
- Can I Install the Thermostat Inside the Shower?
- Installing a relay
- Mounting the 3iE Energy Monitoring Floor Heating Thermostat
- Basic Installation of the 3iE Energy Monitoring Floor Heating Thermostat
-
Troubleshooting
- What does it mean if my thermostat reads “overload” on this display?
- What does it mean if my thermostat reads error message “ER1” on the display?
- What does it mean if my thermostat reads error message “ER2” on the display?
- What does it mean if my thermostat reads “Ground Fault Error” on the display?
- What does it mean if my thermostat screen is black and will not turn on?
- Why is my floor not heating but there are no error messages?
- Why does my thermostat trip every time it reaches the same temperature?
- What if my thermostat says system is on however the floor is not heating up?
- What if my Sensor probe reading higher or lower than actual temperature?
- Why is my floor temperature reading incorrect?
- What does it mean if my thermostat reads “ER 1 Out” on the display?
- Un-Mounting Your Thermostat
- What does it mean if my thermostat reads “output fault detected” on the display?
- What does it mean if my thermostat reads “heater error” on the display?
- What is causing my thermostat to keep tripping requiring that I press the reset button?
-
Miscellaneous questions
- How can I turn my system on or off completely?
- Why is my floor not reaching target temperature?
- Is it normal if my thermostat makes a clicking noise?
- When my screen goes dark, will my floor continue to heat?
- When I push the test monthly button on my thermostat, the screen goes red and tells me to call Warmup. Should I be worried?
- Does the 3iE have a battery backup?
- Programming
- Wiring