Using self-lever or thinset depends on the type of flooring being installed and preference.
Preparing for your project
For tips for connecting and programming your system click “Read More”.
The thermostats come with a 9’ sensor cable to detect the temperature under the floor finish. The end of the probe wire contains a capped sensor that should be evenly centered between two heating cables at least 12” into the heated area. At no time should the probe wire cross the heating cable.
Please verify that the circuit can handle the amount of amperage your heating system requires. Your thermostat can only handle up to 15 amps so if you are connecting multiple heaters to one thermostat location, you may need to use a relay and a larger breaker. Your or your electrician can find out the amperage rating of your specific floor heating system in installation manual or printed on the box. Note: Just because the Warmup thermostats are dual voltage, this does not mean you can supply any voltage to your heating system. You must supply the voltage supplied to the voltage of your specific heater.
Wondering about the maximum load of the Warmup 6iE thermostat? Find the information you are looking for here in this post.
Curious about what types of heating systems the 6iE thermostat is compatible with? Find your answer here in this post!
Are you looking for the dimensions of the 6iE? Find a detailed diagram with all the dimensions you are looking for here in this post.
Are you wondering how much snow fall a snow melting system can handle? Read more about snow melting technology here.
Wondering what the dimensions are of Warmup towel warmers as you prepare for your project? Find the information you need here.
It is not recommended to install floor heating under a tub. A claw foot tub can have heat under it but it is not necessary to heat the floor.